International Buyers Please Read

Prusa Enclosure Design Beta Almost Here

We've had so many requests for Prusa MK3 3D printer enclosures that I mocked up this one just to see how it looked. There is a plan to add a custom 3D printed piece to vent air to the power supply, which will be easier than moving the supply to the outside, which requires buying longer cables, OR just putting a few holes in the enclosure next to it, which lets all of the heat out.
 
Sure, the Lack DIY enclosure is fun, but some people are too busy to go to a lot of effort and just want a professional looking enclosure you can put together in 20 minutes.
 
Let us know if you want to be a beta tester and get the early version for 50% off of list price.

Leave a comment

Please note, comments must be approved before they are published